平板式振动器机座的工艺工装设计

时间:2020-08-29 13:24:11 自动化毕业论文 我要投稿

平板式振动器机座的工艺工装设计


平板式振动器机座的工艺工装设计

摘  要:分析了平板式振动器机座的技术要求,根据大批量生产类型,制定了平板式振动器机座的机械加工工艺过程,设计各加工工序,包括各加工面和孔的`加工方法、方案和切削用量的选择。对加工精度要求高的孔采用粗镗—半精镗—精镗的加工方法,平面的加工采用粗-精的方法。根据基准统1原则,选择平板式振动器机座底面及其上两工艺孔为精基准。同时设计了平板式振动器机座加工过程中的夹具、镗夹具和钻夹具。其中两端面夹具和镗主轴孔夹具采用“1面两孔” 定位,螺旋压板夹紧;钻端面3个孔夹具采用“1圆面和1防转销”定位的盖板式钻模.

关键词:平板式振动器机座;   加工工艺;   工序设计;   夹具


Process planning and Fixture over The chassis of Flat-vibrator

Abstract:This thesis analyzes the technical requirements on the chassis of flat-vibrator, formulates its machining process, and plans all processing techniques according to the mass-production type, including processing methods of all machined sueface, processing plan and the choice of cutting amount. The processing method of rough boring-boring-precision boring is adopted.in high precision hole and the rough milling-precision milling method is used in plane process.According to the principle of the basis unity, the botton and two technique holes of the chassis of flat-vibrator are choosed as precise basis. At the same time, it designs the milling , drilling and boring fixtures used in machining process of the chassis of flat-vibrator. Among the three fixtures, milling side fixture and boring fixture use”one surface-two holes”position with spirial platen clamping and 3 hole drilling fixture uses “one cylinder-one bolt”position with plat drilling mould.

Keywords: The chassis of Flat-vibrator;Machining process;Process planning;Fixture

包括:毕业设计图纸、毕业论文、开题报告、任务书、实习报告、外文翻译

【平板式振动器机座的工艺工装设计】相关文章:

1.数控车床的工艺和工装

2.基于电火花成型的联接套加工工艺及其工装设计

3.轴承工装管理系统的设计与实现

4.CJ20-40交流接触器工艺及工装

5.工装设计助理岗位职责

6.石油化工装置工艺管线系统试压研究分析

7.离子交换工艺的设计

8.瓶盖模具设计与工艺

9.直升飞机座舱环境对飞行影响